Back to top

1991 Crowther Custom 46

United States

$150,000

STELLA EDEN was built in Stewart, Florida in 1991 by Bruce Osborne’s Offshore Catamarans off the molds of the Lock Crowther Super Shockwave 42. In 2001, the hulls were cut apart in the middle and a 4’ section was scarfed in extending the overall length to 46’. The hulls are cored with Corecell foam. 

STELLA EDEN has long narrow hulls with twin daggerboards plus the characteristic Crowther tulip bows. She is easily sailed in the low to mid teens and is capable of speeds in excess of 20 knots.

She has been a fixture on the mid-Maine coast as a day-charter boat. With some simple additions she could easily be made into a cruising boat.

Basic Boat Info

Price: $150,000
Boat Name: Stella Eden
Make: Crowther
Model: Custom 46
Year: 1991
Condition: Used
Category: Sail
Construction: Fiberglass
Boat Hull ID: OFZ40003B591
Has Hull ID: Yes

Dimensions

Length: 46 ft / 14.02 m
Length Overall: 46 ft / 14.02 m
Beam: 24 ft / 7.32 m

Engines / Speed

Engines: 2
Engine #1 Specs:
  • Make: Yamaha
  • Model: 9.9 High Thrust
  • Fuel: Unleaded
  • Engine Power: 10hp
  • Type: Outboard 4 Stroke
  • Propeller Type: 3 Blade
  • Year: 2016
  • Engine Location: Port
Engine #2 Specs:
  • Make: Yamaha
  • Model: 9.9 High Thrust
  • Fuel: Unleaded
  • Engine Power: 10hp
  • Type: Outboard 4 Stroke
  • Propeller Type: 3 Blade
  • Year: 2017
  • Engine Location: Starboard
Total Engine Power: 20hp

Other

Heads Count: 2
Boat Class: Multi-Hulls, Catamaran

Disclaimer

Sail Away Catamarans Yacht Sales is pleased to assist you in the purchase of this vessel. This boat is centrally listed by The Multihull Source.


Dimensions

Length Overall: 46 ft
Beam Overall: 24 ft
Minimum Depth: 3' 9"
Displacement: 12000 lbs

Engines

Stella Eden is powered by twin Yamaha 9.9HP High Thrust 4-Stroke outboards.
Outboards were new, one in 2016, the other in 2017.
The outboards are mounted on sleds hinged off the rear beam. They are each controlled by a multi-part block & tackle system.

There are 4x 6 Gal plastic gas tanks

New Shift/Throttle control cables for 2019

Accommodations

There is a double berth aft in each hull and a single berth forward in the port hull.
Doors provide privacy for each cabin.

There are two head compartments, one starboard forward and one one midship in the port hull. The starboard head is equipped with macerator pump.

The holding tank has a 20 Gal capacity. The holding tank is fiberglass.

The water tankage is bladders stored in the main beam.

The bridgedeck salon has a large center table.

Galley

Four burner Force 10 stove with oven.
Double stainless steel sink.
Pressure fresh water faucet at sink.
Pressure salt water faucet at sink.
Plenty of counter-top space for food prep.
Generous amount of storage space.
2x 20lb propane tanks.

Electrical

4x 115 AmpHr deep cycle AGM batteries (460 AmpHr total), 2 yrs old.
300W of solar panels (4x 32W UniSolar; 4x 43W Siemens).
Pros Sine 1000 120V inverter

Electronics

Garmin GPS Map 820 10" color charterplotter (2 seasons old).
B&G Hydra 2 Speed and Depth.
VHF - West Marine Aurora.
Barometer

Sails

The sails are by Winn Fowler at Maine Sailing Partners, Yarmouth, ME.
Full battened main, blade jib on furler, screacher on bowsprit.
The sails are from 2012.

ProFurl furling system for the jib

Deck

The MAST is a 53' aluminum Sparcraft wing section with a 15" chord length and approx 6" wide.
The mast rotates.
Mast rotation control lines.
Twin Daggerboards
Hydraulic steering system
Harken traveler
Winch complement: 6 total
 - 2x Barient 28
 - 2x Lewmar 40ST
 - 2x Barient 24 on the mast

The cockpit is covered by a hardtop

Rigging

The running rigging varies. The halyards were replace in 2013. Some running rigging was replaced with new dyneema lines in a number of places over the last 2 years. The traveler line, daggerboard lines, and main sheet are from before 2011.

The standing rigging dates are unknown. It is over 10 yrs old. It has been inspected and is Norseman fittings.

The chain plates were remounted in 2012.

Hull work has only been painting and fixing scratches from Hinckley’s travel lift when the boat was hauled this fall (the boat is stored at the Hinckley Yacht yard in Southwest Harbor, ME).

The daggerboards are in very good shape, no delays, cracks or other problems.

Tender

8' Zodiac hard bottom inflatable tender in good condition.
8HP Nissan 2-Stroke outboard (ca. 1990s).
Stored on dinghy davits.

Additional Information

New dodger canvas and window for 2019.

Topsides painted prior to launching for 2019.

Anchors: 1 Bruce 35 lb and 1 Danforth 35 lb

There is a windlass housing and wiring but there is no actual windlass present.

There is a Force 10 stainless gas barbecue.

The boat is plumbed for hot water but there is no hot water heater.

Fenders and docklines.

Disclaimer

The Multihull Source offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

Contact Us